Napoleon III Porcelain Inset Kingwood Jardiniere Cachepot with Gilt

• Serpentine - Resembling a serpent, in the form of an elongated 'S'. A serpentine front is similar to a bow front, except that the curve is shallow at each end, swelling towards the middle. The term presumably derives from its similarity to a moving snake or serpent. Serpentine fronts are usually veneered, with the carcase either being cut and shaped from a solid piece of timber, or built in the 'brick' method.
• Cache Pots - A cache pot, also spelt as cachepot, is a type of decorative container used to hold a flower pot containing a potted plant. The cache pot is a separate container from the plant's actual pot and is typically used to enhance the appearance of the plant or to hide an unattractive or functional flower pot. They are also used to protect the surface of furniture or floors from the water and soil of a potted plant. They can also be used to conceal an unsightly plastic nursery pot, or to provide a drainage layer for a plant.
  
  Cache pots have been used throughout history to enhance the beauty of potted plants and were particularly popular during the Victorian era. Major manufacturers of ceramics cache pots included Minton, Wedgwood, Meissen and Royal Worcester.
• Veneers - Veneers are thin sheets of well-figured timber that are glued under pressure to the surface of a cheaper timber for decorative effect, and then used in the making of carcase furniture.
  
  Early veneers were saw-cut so were relatively thick, (up to 2 mm) but is was realised that saw cutting was wasteful, as timber to the equivilent of the thickness of the saw was lot on each cut.
  
  A more efficient method was devised to slice the timber, either horizontally with a knife, or in a rotary lathe.
  
  Flame veneer, commonly found in mahogany or cedar furniture, is cut from the junction of the branches and main trunk. So-called fiddleback veneers, where the grain is crossed by a series of pronounced darker lines, is usually cut from the outer sections of the tree trunk.
  
  During the 17th and 18th centuries, and in much of the walnut marquetry furniture made during the latter part of the 19th century, the veneer was laid in quarters, each of the same grain, so that one half of the surface was the mirror image of the other.
  
  The use of veneer allows many other decorative effects to be employed, including stringing, feather banding, cross banding, and inlaid decorative panels in the piece. The carcase over which veneer is laid is usually of cheaper timber such as pine, oak or, sometimes in Australia during the first half of the 19th century, red cedar.
  
  The important thing to remember about veneers is that prior to about 1850 they were cut by hand, and were consequently quite thick - ranging up to about 2mm deep.
  
  From the mid-19th century veneers were cut by machines and were almost wafer-thin. This is a critical point when trying to judge the approximate age of veneered furniture.
• Gallery - On furniture, a gallery is a small upright section, frequently pierced and decorated, around the tops of small items of furniture, such as davenports, side tables, and so forth. Galleries are made in brass or bronze,and be fretted, pierced or solid timber. A three-quarter gallery is one that surrounds three of the four sides of a table, desk or other top.

This item has been included into following indexes:

• jardinieres / planters - wooden 48
• pedestals and columns, material - gilt and gilded 104
• planters and jardinieres - wooden 133
• urns, planters, jardinieres and jardiniere stands - indoor 61